❄ Ice Machine Code Lookup

Ice machine flashing a code or beeping?

143 documented fault codes across Hoshizaki, Ice-O-Matic, Manitowoc and Scotsman, verified against service manuals — what each one means, what to check yourself, and when it's a tech call.

How to read your machine's code

Each brand reports faults differently, so first work out what kind of signal you are looking at. Then open that brand's page or one of the most-searched codes below.

  • Manitowoc: a display showing E-codes means Indigo NXT or original Indigo. Many numbers match across both (E01 long freeze, E02 long harvest), but not all, so use your series' table. A red wrench light with no display is a NEO undercounter. Flashing lights on restart are an S-model or Q-model safety limit: one flash is a long freeze, two is a long harvest. All Manitowoc codes.
  • Hoshizaki: most KM-series crescent cubers have no error display. They beep, and the count between pauses is the diagnosis, so count through two full repeats. The DCM-270BAH dispenser is also beep-counted. DCM-60KE / DCM-120KE dispensers show letter codes: lowercase c-codes are cautions, uppercase E-codes are shutdown faults. IM-series square cubers show E1, E2, or a generic EE. All Hoshizaki codes.
  • Scotsman: on Prodigy cubers, numbers are faults and the letters F, H, b, C, O, and d describe what the machine is doing, not a fault. Flashing means the controller is retrying; steady means it shut down and needs a reset. A blinking red Water light means no water detected. All Scotsman codes.
  • Ice-O-Matic: Elevation Series (CIM) cubers signal through the Power and Clean buttons. A quick red Power flash is Error 1, a slow Power flash while off is Error 2, and both flashing quickly is Error 3. GEM / MFI nugget and flake machines use named indicator lights. All Ice-O-Matic codes.

One reset is reasonable after you fix the obvious cause. If the same code comes back, the condition is real: work the checks on that code's page instead of resetting again.

Most searched codes

Local service

Guides

Before you call for service

Scale and dirt cause more ice machine codes than failed parts do. Long freeze, long harvest, and high condenser temperature faults on every brand usually trace back to a dirty evaporator or condenser, a spent water filter, a closed water valve, or poor airflow. Each code page lists what you can safely check yourself, what a technician would look at next, and the service manual it was verified against.

Frequently asked questions

Why is my ice machine beeping instead of showing a code?

Most Hoshizaki KM-series crescent cubers have no error display. The control board reports faults by a repeating beep count. Count through two full repeats, then look up that beep count on the Hoshizaki page.

Should I reset my ice machine when it shows an error code?

Fix the likely cause first, such as a closed water valve, a dirty condenser or air filter, or scale, then reset once. If the same code returns, stop resetting. The condition is real, and a technician should diagnose it.

Where do the codes on this site come from?

Every code is checked against the manufacturer's service manual or authorized-distributor documentation, and each code page cites its source document.

Which codes mean I should turn the machine off?

Repeated high-pressure trips are the clearest case. A Hoshizaki DCM-270BAH 4-beep alarm means the high-pressure switch opened three times within an hour, and Hoshizaki recommends leaving the unit off and calling for service. Recurring voltage alarms are a job for an electrician, not an ice machine repair.

Equipment still down? If you're in Middle Tennessee or Central Alabama, see who services commercial ice machines near you:
Nashville, TN →  ·  Birmingham, AL →